This program provides experiences which enable students to develop competencies necessary for employment in and/or continued education in welding. Emphasis throughout the program is placed on developing skills in the following areas: safety, metal identification, oxy-acetylene welding, metal cutting processes, shielded metal arc welding, gas metal arc welding, gas tungsten arc welding, and blueprint reading.
Program requirements may change over time. Specific degree/graduation requirements are determined by a degree audit.
Focuses on basic arithmetic and calculations necessary for solving shop oriented problems involving geometric figures, formulas and algebra. Students draw graphs. A scientific calculator is required, so there is little or no memorization.
Familiarizes the student with the need for heat treatment of metals and the processes and techniques used and the resulting effects. Also includes a study of the machinability of metals and the contributing physical and metallurgical factors.
Fundamentals, principles, and practices involved in producing and reading industrial blueprints. Covers basic through advanced blueprint reading and basic drafting procedures. Advanced work is adjusted to special interest groups.
This course provides an introduction to shielded metal arc welding. Students learn to set up equipment, identify electrodes, strike and run beads in the flat position.
This course introduces gas metal arc welding procedures and equipment. Students learn to perform single and multiple pass welds in the flat position with gas metal arc welding equipment.
This course introduces students to gas tungsten arc welding equipment and procedures. Welds are prepared in flat, horizontal and vertical positions on both ferrous and non-ferrous metals.