Academic Program Model

Basic Welding (NDP.BWEL)

This program provides an introduction to basic welding practices and skills including metal layout and cutting, SMAW, GMAW, and GTAW welding processes. Industrial safety and other skills such as blueprint reading are covered. This certificate is directly applicable to a more advanced welding certificate and a welding associate's degree.

Program requirements may change over time. Specific degree/graduation requirements are determined by a degree audit.

FIRST YEAR
First Semester		Hours
APT-041	Applied Mathematics I APT-041 Applied Mathematics I Fundamentals of basic arithmetic, calculator usage, simple equations, word problems, algebra, right triangles, charts and graphs. Course Outline	3.0
TEC-040	Blueprint Reading for Industry I TEC-040 Blueprint Reading for Industry I Fundamentals, principles, and practices involved in producing and reading industrial blueprints. Covers basic through advanced blueprint reading and basic drafting procedures. Advanced work is adjusted to special interest groups. Course Outline	2.5
TEC-043	Industrial Safety TEC-043 Industrial Safety Designed to give the student basic information and procedures concerning industrial safety awareness and accident prevention. Course Outline	1.0
WEL-056	Metal Cutting and Fabrication WEL-056 Metal Cutting and Fabrication This course is designed to provide an understanding of metal cutting and fabricating processes and weld joint design.(Repeatable 3 Times) Course Outline	2.0
WEL-057	Welding Fundamentals WEL-057 Welding Fundamentals Course will cover basic welding processes, including: Oxy-Acetylene welding, Arc welding, Cutting and Brazing. Course Outline	2.5
	Semester Totals	11.0

Total Program Hours

11.0

Call Counseling Services: 217-234-5232
Email: counsel@lakelandcollege.edu

Faculty Contact: John A. Gentry, SR
Faculty Email: jgentry@lakelandcollege.edu
Faculty Phone: 217-234-5065

*	There are prerequisites, course requisites, or minimum
*	placement test scores for this course.
**	Electives must be approved by the Program Coordinator
+	Course only offered fall semester
++	Course only offered spring and summer semester
+++	Course only offered spring semester
++++	Course offered in summer term only
^	SOS 050 Human Relations and PSY 271 Introduction to
^	Psychology cannot be used as a social science elective
^^	Consult Academic Advisor for appropriate course
^^^	Course requires a 30-hour practicum experience in addition
^^^	to classroom lecture hours
^^^^	ECE 120 and ECE 125 must be taken the same semester

Basic Welding (NDP.BWEL)

APT-041Applied Mathematics I

TEC-040Blueprint Reading for Industry I

TEC-043Industrial Safety

WEL-056Metal Cutting and Fabrication

WEL-057Welding Fundamentals

Semester Totals

Total Program Hours

APT-041
Applied Mathematics I

TEC-040
Blueprint Reading for Industry I

TEC-043
Industrial Safety

WEL-056
Metal Cutting and Fabrication

WEL-057
Welding Fundamentals