Applied Mathematics I
APT-041Fundamentals of basic arithmetic, calculator usage, simple equations, word problems, algebra, right triangles, charts and graphs.
Blueprint Reading for Industry I
TEC-040Fundamentals, principles, and practices involved in producing and reading industrial blueprints. Covers basic through advanced blueprint reading and basic drafting procedures. Advanced work is adjusted to special interest groups.
TEC-043Designed to give the student basic information and procedures concerning industrial safety awareness and accident prevention.
Properties of Metal
TEC-070Familiarizes the student with the need for heat treatment of metals and the processes and techniques used and the resulting effects. Also includes a study of the machinability of metals and the contributing physical and metallurgical factors.
Metal Cutting and Fabrication
WEL-056This course is designed to provide an understanding of metal cutting and fabricating processes and weld joint design.(Repeatable 3 Times)
WEL-057Course will cover basic welding processes, including: Oxy-Acetylene welding, Arc welding, Cutting and Brazing.
Shielded Metal Arc Welding I
WEL-047This course provides an introduction to shielded metal arc welding. Students learn to set up equipment, identify electrodes, strike and run beads in the flat position.
Shielded Metal Arc Welding II
WEL-048In this course students learn to perform single and multiple pass welds with shielded metal arc welding equipment in all positions.
Gas Metal Arc Welding I
WEL-058This course introduces gas metal arc welding procedures and equipment. Students learn to perform single and multiple pass welds in the flat position with gas metal arc welding equipment.
Gas Metal Arc Welding II
WEL-059This course teaches students to perform gas metal arc welds in the horizontal, vertical and overhead positions using single and multiple pass welds.
Gas Tungsten Arc Welding
WEL-061This course introduces students to gas tungsten arc welding equipment and procedures. Welds are prepared in flat, horizontal and vertical positions on both ferrous and non-ferrous metals.
Total Program Hours